DISBON DisboFLOOR 475 OS 2K-EP Flow Coating 30kg

DISBON DisboFLOOR 475 OS 2K-EP Top Sealer 30 kg – for multi-storey and underground car parks

DisboFLOOR 475 OS is a pigmented 2K epoxy resin coating used as a top sealer in the Disbon OS 8 car park system. It is resistant to frost and de-icing salts, chemical resistant and virtually odourless – for permanently protected concrete surfaces in multi-storey car parks, underground garages and trafficked areas.

The coating meets the requirements of DIN EN 1504-2 for surface protection systems for concrete and is low-emission (AgBB-compliant).

Benefits

• Top sealer in the Disbon OS 8 car park system
• Frost and de-icing salt resistant
• Good chemical resistance
• Virtually odourless, low-emission (AgBB-compliant)
• Meets DIN EN 1504-2
• Glossy, easy-to-clean surface

Areas of application

• Multi-storey and deck car parks
• Underground garages
• Trafficked concrete surfaces exposed to de-icing salts

Technical data

• Material base: 2K epoxy resin, total solid according to German construction chemistry
• Gloss level: glossy
• Container: 30 kg (Comp. A 24.6 kg, Comp. B 5.4 kg)
• Mixing ratio: A : B = 82 : 18 parts by weight
• Density: approx. 1.55 g/cm³
• Viscosity: approx. 1,400 mPas
• Shore hardness: approx. D 77
• Flexural tensile strength: approx. 50 N/mm²
• Abrasion (Taber): 42 mg/30 cm²
• Pot life: approx. 50 min. (10 °C), approx. 30 min. (20 °C), approx. 15 min. (30 °C)
• Walkable and recoatable: after approx. 45 h (10 °C), 14 h (20 °C), 10 h (30 °C)
• Fully loadable: after approx. 10 days (10 °C), 7 days (20 °C), 5 days (30 °C)
• Storage: cool, dry, frost-free, at least 12 months

Consumption

As a roller coating, approx. 0.7–0.9 kg/m² – a 30 kg container is therefore sufficient for approx. 33–43 m². The exact system structure depends on the Disbon OS 8 car park system technical data sheet.

Application

Application is carried out in accordance with the Disbon OS 8 car park system technical data sheet. Mix components in a ratio of 82 : 18 using a slow-speed stirrer, decant and mix again. Curing can be accelerated with DisboADD 903 accelerator (walkable after approx. 6 or 4 hours at 20 °C).

Application conditions: Material, air and substrate temperature 12–30 °C, rel. humidity max. 80 %, substrate at least 3 °C above the dew point.

Good to know: Colour changes and chalking are possible under the influence of UV and weathering. Organic dyes and certain chemicals can lead to discolouration.

Suitable primer for OS 8: DISBON DisboFLOOR 460 or DISBON DisboFLOOR 461.

Note: The information is taken from DISBON Technical Information No. 475 OS and consists of guide values. For professional use only. Please observe the Technical Information, system data sheet and safety data sheets.